Owens Corning
Architectural shingles
Metal roofing
Tile roofing
GAF
Flat & low-slopeFree roof inspection with deck photos before we talk money - GAF and Owens Corning certified installation
Owens Corning Roofing Company in Dallas: What to Know First
We provide independent Owens Corning roof repair and replacement across Dallas, with most tear-offs completed in 5 to 8 working days and repairs typically handled same-week. An Owens Corning architectural shingle roof in Dallas runs between $11,500 and $24,000 for an average 2,200-square-foot home, depending on the shingle line you choose and what’s happening underneath. If you’re seeing granule loss, curling edges, or water staining in the upstairs ceiling and your roof carries Owens Corning shingles, this page tells you what’s actually going on and what it costs to fix. Call (432) 302-5605 for a written, no-surprise estimate.
How Owens Corning Products Fail on Dallas Roofs
- Duration Series granule loss after hail. Duration shingles use Owens Corning’s SureNail strip, but the granule layer is the first thing Dallas hail takes off. Once granules are gone, the asphalt underneath bakes in the Texas sun and cracks within a season or two. We don’t patch these. We replace the damaged slope and match the color using current Owens Corning stock so the repair doesn’t look like a scar.
- Oakridge curling at the eaves. Oakridge shingles, especially older runs from the 2000s, curl at the edges when attic ventilation is weak. Dallas attics routinely hit 130°F in August, and that trapped heat pushes through the decking and lifts the shingle corners. We fix the ventilation first, then replace the curled shingles. If we don’t fix the airflow, you’re re-roofing in three years.
- Supreme 3-tab losing seal strips. The older Supreme line was a builder-grade 3-tab shingle with a thin sealant strip. After 12 to 15 Dallas summers, that strip fails and shingles lift in the spring windstorms that come through from the west. We can do selective repairs on Supremes, but we’ll be straight with you: when seal failure is widespread, spot repairs turn into a monthly subscription. Full replacement is usually the honest call.
- Valley flashing failures on Owens Corning cuts. Owens Corning shingles installed in open valleys rely on metal flashing underneath. In Dallas, the freeze-thaw cycle we get in January and February works that metal loose over time, and water runs straight into the decking. We see it most in Lake Highlands and Richardson houses built in the 1990s. We replace the valley metal, not just the shingles over it.
- Decking rot under Owens Corning roofs with no drip edge. Some Dallas homes built before 2010 got Owens Corning shingles with no drip edge at the rakes. Water wicks under the shingle edge, the decking rots from the outside in, and the homeowner doesn’t know until the fascia starts crumbling. When we pull those shingles, we add drip edge and replace the rotted decking before anything goes back on.
Styles & brands we work with






Our Owens Corning Roofing Company Process
- 1
You call (432) 302-5605. A live person answers. We schedule a visit and send you the technician’s name and photo before they arrive.
- 2
The technician badges in. Uniformed, background-checked, photo ID at the door. You know exactly who’s walking onto your property.
- 3
We inspect the roof and photograph everything. Grant Whitlock has a rule: no homeowner gets told their roof needs work without seeing the proof. We document granule loss, lifted shingles, flashing gaps, and decking condition with labeled photos.
- 4
You get a written price before any work starts. Not a ballpark. A line-item price for the Owens Corning replacement or repair, with the shingle line and color specified. No change orders, no surprise add-ons.
- 5
The work. We tear off, repair the decking where needed, install underlayment, and put down the Owens Corning shingles per manufacturer spec. That last part matters for your warranty.
- 6
Cleanup and the 365-Day Done Right Promise. We magnet-sweep the yard for nails, walk the roof with you, and hand you the written guarantee on every repair. If it’s not right within a year, we make it right.
See the difference
Before
After
Before
After
Before
AfterWhat Owens Corning Roofing Cost Looks Like in Dallas
Here’s what we quote most often, based on current Dallas material and labor rates:
| Job | Typical Range |
|---|---|
| Repair 3 to 6 Owens Corning shingles (wind/hail) | $275 – $525 |
| Valley flashing replacement on Owens Corning roof | $450 – $900 |
| Partial slope re-shingle (Owens Corning Duration) | $1,800 – $4,200 |
| Full tear-off and replacement (Oakridge, 2,200 sq ft) | $11,500 – $16,500 |
| Full tear-off and replacement (Duration, 2,200 sq ft) | $14,500 – $20,000 |
| Full tear-off with decking repair (adds to any option) | $2,000 – $5,500 |
What moves the price: steep pitch, two-story access, decking rot, and whether your current roof has a second layer to tear off. We also install GAF and CertainTeed, so if the math on Owens Corning doesn’t fit your budget, we’ll show you comparable options. Estimates are free, and the written price never changes after you approve it.
Why Dallas Homeowners Call Mercer Roofing Co Dallas for Owens Corning Work
Most roofing companies in Dallas know Owens Corning as a brand. We know it as a product line with specific failure patterns tied to our climate. Grant Whitlock and our crew have worked hundreds of Owens Corning tear-offs from Oak Cliff to Far North Dallas, and we’ve learned what those shingles do after a decade of Texas heat and hail. You also know who’s coming to your door: we send a name and photo ahead of the visit, and the technician arrives badged and in uniform. Every repair gets a written guarantee, with a free second visit if the fix doesn’t hold. That’s the 365-Day Done Right Promise, and it’s in writing on every Owens Corning job we do.
FAQs
No. As an independent Owens Corning service provider, we follow manufacturer installation specs, which is what keeps your limited warranty intact. If your roof is still under Owens Corning’s stated coverage period, we’ll tell you plainly whether the issue is a warranty item or normal wear, and we’ll document everything.
Do you use OEM Owens Corning parts or aftermarket?
For shingles, we always use genuine Owens Corning product so the color and warranty stay consistent. For flashing, underlayment, and fasteners, we use manufacturer-recognized components from brands like GAF and CertainTeed where they perform equally or better in Dallas conditions.
Most full tear-offs on an average two-story Dallas home take 2 to 5 working days, depending on decking condition and weather. Repairs, like shingle replacement or flashing work, are usually done in one visit.
Most of the time, yes. Owens Corning’s color lines, like Onyx Black, Driftwood, and Estate Gray, have been stable across model years. For discontinued colors, we’ll bring sample boards and match the closest current stock. You’ll approve the match before we nail anything down.
The answer comes down to three things: the age of the roof, how widespread the damage is, and whether the decking underneath is still sound. If you’re seeing granule loss across multiple slopes, curling at the eaves, or leaks in more than one room, replacement is usually cheaper than chasing repairs. We’ll show you the photos either way and let you decide. Call (432) 302-5605 and we’ll give you a straight answer.
Written by Grant Whitlock, Owner, Mercer Roofing Co Dallas at Mercer Roofing Co Dallas, serving Dallas and nearby areas.